Livestock Products

---

 With this design you can easily catch a calf inside using the flip-down gate, you can easily walk inside to treat sick calves, and spreading straw is fast and simple. Leave the whole side open and blow in straw or leave half-open for more wind protection. 

One end contains a walk-through door. There are chains and/or tubing for attaching portable windbreak or freestanding panels to both ends. Put your shelter in the middle and a windbreak on each end for maximum protection. Skylights are along the side peaks to allow sunlight in. Calves won’t go in a dark shelter! With a tall peak, the inside of this shelter won’t heat up as much as shorter shelters. When calves get too hot and go outside in the cold, they get sick. 

• Overall Dimensions: 8′-6″ wide x 24′ long x 8′ tall.
• Estimated weight: 1,800 lbs.
• 8′ gate centered with 8′ sheeting on both sides.
• Roof skylights along both sides.
• 22ga Galvanized decking.
• Outside edges are covered with trim.
• 28″ walk-through door can be open from inside and outside.
• Lifting bar across the top allows you to pick it up from either side with a bucket.
• Chain hooks in front and back for dragging. 

Patented design allows you to rotate the legs without removing them. Legs are fastened to the windbreak so they will not fall out. Simply loosen the bolt and spin the leg. Panels can be lifted with a bucket or through the center with forks to gain extra height for clearing posts and fences.

• 24’ long by 8’6” tall
• Average weight: 900 lbs.
• Frame is constructed out of 2″ x 3″ x 11ga and 2″ x 3″ x 3/16″  Rect Tube
• Legs are 12’6” long made of 3″ Sch40 well pipe and weigh over 100 lbs. each

•  Panels are 5’9″ tall and stand 10″ off the ground.
• 2-7/8″ wellpipe is used to make the main frame and vertical uprights.
• Five 1″ sucker rod are slid through the wellpipe for a stronger panel.
• Rod is welded at both ends.
• Sucker rod is spaced accordingly to help prevent calves from clawing through the bottom.
• 5′ arched or flat legs made from 2-7/8″ wellpipe
• Legs can be welded on or made to swivel.
• Two 3′ chains at one end and 4 slotted chain loop gussets in each corner.
• 24′ panels weigh about 800 lbs. and the 30′ panels weigh about 960 lbs.
  Internal gates can be hung to make it easier for getting in and out of pens.
• 8′, 10′, and 12′ swinging gates can be hung on the ends. Gate hinge is designed so the gate can lay flat against the panel on one side and swing 90 degrees on the other. 

Other Freestanding Panels

• 24′ FSP w/ 3/4″ Rod
• 24′ FSP w/ 1″ Rod
• 24′ FSP Heavy Duty
• 12′ Gates
• 14′ Gates

•  5 bar 20′ 1.25″ 14ga round tubing and 5/8″ for uprights
• 6 bar 20′ 1.25″ 14ga round tubing and 5/8″ for uprights

20' Calf Bunks 

All steel and heavy duty built! Will hold a lot of feed. Also, if your needing freestanding panels or calving supplies call us 

 24' long fenceline bottomless bunks  

All steel and heavy duty built! Will hold a lot of feed. Also, if your needing freestanding panels or calving supplies call us 

Bottomless Feed Bunks

All steel and heavy duty built! Will hold a lot of feed. Also, if your needing freestanding panels or calving supplies call us 

Stand out in your field!

Support Made in the USA products and show your patriotism with this wrap.